Desktop Lamination

I’ve laminated the 1/4" mahogany ply to 3/4" baltic birch ply to form the main body of the two desktops.  I used standard wood glue and a ton of clamps. The glue should be fully cured by tomorrow and then I will cut them to final size and begin to make the solid mahogany front and rear edges for the top and cut the tops for the solid mahogany breadboard ends.

The final thickness of the laminated top is only about 7/8 of an inch.  I was shooting for a full 1", but of course the finished thicknesses of the birch and mahogany plys are thinner than their full 1/4" and 3/4" dimensions due to the nature of manufactured ply now-a-days (finish sanding at the factory reduces the thickness).  So, I think that my original design thickness of the breadboard ends (1 and 1/8") needs to be reduced to only 1."   I only want the breadboard ends to be about 1/8" proud of the rest of the top.   I will re-plane the breadboard ends to remove another 1/8". 

About mattsanf

Matt Sanfilippo is the Chief Partnership Officer (CPO) for the College of Engineering at Carnegie Mellon University (CMU) and Co-Director of its Engineering Research Accelerator. In this role, Matt coordinates and enables strategic and sponsored research opportunities across the college, and stewards the development of proposals for major research opportunities along strategic themes. Additionally, he enables collaboration among the college's research institute/center executive directors, and industrial and government relations personnel in the pursuit of opportunities with industry, federal and state governments. Before becoming CPO for the College, Matt was the Senior Executive Director for Research Initiatives, the Executive Director of CMU's SII (Smart Infrastructure Institute) and ICES (Institute for Complex Engineered Systems), and Associate Director of PITA (Pennsylvania Infrastructure Technology Alliance) and RAMP (Research for Advanced Manufacturing in Pennsylvania). Before CMU, Matt was Managing Director of Applied Technology for Michael Baker Corporation, an engineering and energy services firm. Matt managed Baker's technology division including Geographic Information System (GIS), software and web development, multimedia, virtual reality, visualization, Global Positioning System (GPS), mapping and surveying services. Before joining Baker, Matt was an Innovation Director for Redleaf Group, a Venture Capital/Operating Company focused on information security, supply chain and mobility solutions. While at Redleaf, Matt managed technical due diligence for seed-stage investments and coordinated relationships between Redleaf and their partner companies. Prior to Redleaf, Matt was CIO of GZA GeoEnvironmental Technologies, an infrastructure engineering firm, and operations manager for their Internet start-up that focused on web-technologies for health and safety and manufacturing metrics. Matt is on the board of Larson Design Group (LDG), past Chairman of the Board for the Pittsburgh Botanic Garden, current board member of the Pittsburgh History and Landmarks Foundation (PHLF), current Vice President of the Sewickley Heights Gun Club (SHGC) and former member of the Information Sciences and Technology Advisory Board for the Pennsylvania State University Beaver. Matt is also former Vice President of the Pittsburgh Chapter of the Association of Internet Professionals and former Vice President of the Board of Trustees for Baker Combined Charity of Pennsylvania.

Posted on January 18, 2006, in Woodworking. Bookmark the permalink. Comments Off on Desktop Lamination.

Comments are closed.

%d bloggers like this: